My workflow auto-activity with dm_noop_auto_method is waiting in pending state. How can I make ot pa

Hi,

I designed a workflow with a last activity as auto-activity with dm_noop_auto_method as the end activity. I installed and started a workflow instance. My workflow is stopped waiting at the auto activity in pending state. I expected it to pass through and 'end' the workflow, but it did not. How can I make it pass through without any operation?

Please share your knowledge and experience.

Thanks.

Find more posts tagged with

Note:

If there are Accepted Answers, those will be shown by default. You can switch to 'All Replies' by selecting the tab below.

Accepted answers

DCTM_Guru

Is your JMS running? Try restarting it. If it still doesnt work, I would check the JMS logs and look for specific error messages. These are out of the box server methods and should work as designed.

All comments

DCTM_Guru

Try using dm_noop_auto_method_java. This is the java version of the same routinr that is the supported method going forward.

athati

Thanks Johnny.

I used dm_noop_auto_method_java. Also I did select If method fails "Continue Execution" instead of "Stop Execution" option, but still my workflow is waiting in "pending" state.

Please advise me.

Thanks.

DCTM_Guru

Is your JMS running? Try restarting it. If it still doesnt work, I would check the JMS logs and look for specific error messages. These are out of the box server methods and should work as designed.

adalbero

Verify if Java Method Server is running.

athati

Thanks Johnny and Adalbero.

I started JMS and my workflow auto method did run successfully.

Thank you for your help.