Workflow - Reactivate a process

Dear members,
Does anyone know a way to reactivate a process that has been terminated by using WOM API? Please kindly advise, thank you!

Find more posts tagged with

Comments

Nicholas

Dear members,
Does anyone know a way to reactivate a process that has been terminated by using WOM API? Please kindly advise, thank you!

You can start the workflow process using the start() method of WorkflowProcess interface.

Thanks Nicholas

cchai01

Thank you so much Nicholas!! You're awesome. So I would assume that by using start() method of WorkflowProcess interface, I can reactivate a process from where it is stopped/deactivated, correct? Thanks!

Nicholas

I think, this is not possible to start a workflow somewhere in between as you are saying that you terminated the workflow and want to start it from the terminated point. Where you will save the workflow state/, where it terminated?
This is just a common sence that if a process (workflow) has terminated completely you can not start again from same point bypassing the previous steps. My previous answer was relevant to the starting it again (reactivate) and it was not mentioned that you want to start it from same point where the process was terminated.

Hope this help you

Thanks Nicholas

cchai01

Dear Nicholas,
Thank you for your response. If there is no way to reactivate a process from way it is stopped, is there any way to put a process in a "on hold" status instead of terminating it?

Please advise. Thank you!

Nicholas

Not sure but I think, this could be possible by adding long time stamp or some other way. You might need a bit more research on this.

Hope this help

Thanks Nicholas