Finish button on DCT

Hi,
We have a workflow instantiated when the user clicks on finish button in the DCR. However when the workflow is initiated and the first (CGI) task is completed, the DCR is re-opened. Is there a way to avoid the DCR from being re-opened?

TIA!

Find more posts tagged with

Comments

ISCBorisB

Hi,
We have a workflow instantiated when the user clicks on finish button in the DCR. However when the workflow is initiated and the first (CGI) task is completed, the DCR is re-opened. Is there a way to avoid the DCR from being re-opened?

TIA!

It's your Workflow. Apparently (one of the?) transition option goes to the Task that re-opens DCR for editing.

It is quite possible that you simply reused a Workflow that operates correctly when opened from the "New Job".
If so, you'd have to either create a dedicated WF without DCR Editing Task for tt_data switch or make the existing WF
instantiation smarter so that it identifies instantiation source and bypasses transition to DCR Editing as required.

Bhargav Coca

If you want a more precise answer post your wft.

Thanks

Kavitha_Sundaram

Hi,
I have attached the WFT. As you might notice there is no "Edit DCR" task in the wft.
I think the difference in behavior between the "finish" button vs. "submit" is because of the wft engine itself.

I would appreciate your inputs. Thanks.

Kavitha_Sundaram

Hi,
Was able to do this by passing the "done_page" paramater to the "transitiontask" URL.