MediaBinWebService Services setup problem

When I tried to access the Mediabin Web services from my system
Its giving as, can any suggest how to make the changes in the placeholders

ValidateCurrentUser

Test

The test form is only available for requests from the local machine.
SOAP
The following is a sample SOAP request and response. The placeholders shown need to be replaced with actual values.

http:///MediaBinWebService/MediaBinServer.asmx?wsdl

Find more posts tagged with

Comments

msrinivas

You can only perform the test being on the server. You cannot do it remotely.

MadhaviPalvai

You can only perform the test being on the server. You cannot do it remotely.

I am not getting help on how to invoke the validateuser service remotely.Since i need to configure it the Teamsite ECM - WSDL URL.
How to configure soap url to access from teamsite.I checked in all the docs.But could not find any help

msnider

First, you will need to ensure that you have properly installed the MediaBin web service. To do this you need to access the MediaBin web service test ASMX page from the machine hosting the MediaBin web service, as Srinivas had mentioned, since invoking the methods from the test ASMX page are only supported on the local host.

So, on the machine hosting the web service you should open a web browser and navigate to http://localhost/MediaBinWebService/MediaBinServer.asmx.

Once there, select and invoke the two methods, ValidateCurrentUser and TestMediaBinConnection. The results will vary depending on how you are planning on using the web service in conjunction with the ECM connector. If you are planning on logging in as a guest user, then those two methods should return a named user and a successful login message. If you are planning on using Trusted LDAP/Trusted Client, those two methods will return AnonymousUser and a message that you will need to call CreateAuthenticationTicket and if so then you will also need to specify the Trusted client hint (which you should have already specified in the installer if this is the configuration you are using....if you didn't you can change the web.config now)

Once you have run those two tests successfully, you should be able to connect using the ECM connector by specifying the url to the web service as:
http:///MediaBinWebService/MediaBinServer.asmx where is either the DNS name or IP address of the machine hosting the MediaBin web service. If you are using Trusted LDAP, then you will also need to specify the hint that you specified in the web.config.

Mark

finalp.bmp