Inactivate not required

Hi all,

I have a wft file which is very much working, however i have an issue as per my requirements. When i intantiate the job and view using iwgetwfobj i found the task within {inactivate} tag of Reactivate_Task .

Copy_And_Deploy_Conflict_FrontEnd and Copy_And_Deploy_Non_Conflict_FrontEnd are parellel tasks, however whenever one of them goes to failure task flow (Notify_User_of_Copy_Deploy_Failed_Task) the other gets inactivated. When it runs as a success, the other stands still as active.

This is because, after failure task ... the task Reactivate_Task makes the other inactive. I have not defined the activation or inactivation.

Please help. Thanks in advance. (WFT file attached for reference)

Find more posts tagged with

Comments

kaalraa

Any expert comments from anyone or IWOV people??

Adam Stoller

Any expert comments from anyone or IWOV people??

Turn on Workflow Debugging, and examine the job specification created from your WFT.

kaalraa

Turn on Workflow Debugging, and examine the job specification created from your WFT.

Hi Adam,

If you see the wft file, the Reactivate_Task task is inactivating every task which is going to error flow. I had checked the job thru CLT using iwgetwfobj.

Thanks for your response.

nipper

Adam suggested you put the WF in debug mode and post the job spec file created by the WFT.

kaalraa

Could anyone be kind enough to provide the code which can put the wft in debug mode?

Thanks.

ISCBorisB

Could anyone be kind enough to provide the code which can put the wft in debug mode?

Thanks.

Check out this article How to write out workflow job specification files? and see how it's done in ".../wft/solutions" Samples

kaalraa

Thanks Boris!!

Check out this article How to write out workflow job specification files? and see how it's done in ".../wft/solutions" Samples

kaalraa

Please find the out come of debug mode. Problem still persists.

sort.jpg

kaalraa

Any suggestions or pointers??