Depoloy and Run Script getting executed twice

Hi All,

We have set up a deploy and run script for our replication farm which consists of two nodes i.e. two servers.

The issue is although the deployment is happening siamultaneously on both the servers the script is also getting executed twice.

Can we execute the script just once, finally after the deployment has been completed on both the servers.

Thanks & best Regards
Gursher

Find more posts tagged with

Comments

Migrateduser

Try to use for executing the DNR script after element in the config file instead of DeployNRun element.

-Anurag

Adam Stoller

Hi All,

We have set up a deploy and run script for our replication farm which consists of two nodes i.e. two servers.

The issue is although the deployment is happening siamultaneously on both the servers the script is also getting executed twice.

Can we execute the script just once, finally after the deployment has been completed on both the servers.

Thanks & best Regards
Gursher

If the script runs on the source side - you can use a dnrDeploymentJob (note the 'Job') "after" and it will only run once. Check the manuals / DTD because the xpath for dnrDeploymentJob is a little bit different than the xpath for dnrDeployment.

Migrateduser

Sorry I meant to say dnrDeploymentJob but this forum editor doesn't like less than and greater than symbols Smiley Happy