Stream serve version 5.6.2 [ST] - Using Array

Sachen

Hi,

In One of my ST Project, I am using array, it works good if the length of array is around 400, but if the length of array is more say around 1000 or more than it does not print.

For example, below is the value of array - $arrlnsublot[0]:

TEST-23-1918, TEST-23-1919, TEST-23-1920, TEST-23-1921, TEST-23-1922, TEST-23-1923, TEST-23-1924, TEST-23-1925, TEST-23-1926, TEST-23-1927, TEST-23-1928, TEST-23-1929, TEST-23-1930, TEST-23-1931, TEST-23-1932, TEST-23-1933, TEST-23-1934, TEST-23-1935, TEST-23-1936, TEST-23-1937, TEST-23-1938, TEST-23-1939, TEST-23-1940, TEST-23-1941, TEST-23-1942, TEST-23-1943, TEST-23-1944, TEST-23-1945, TEST-23-1946, TEST-23-1947, TEST-23-1948, TEST-23-1949, TEST-23-1950, TEST-23-1951, TEST-23-1952, TEST-23-1953, TEST-23-1954, TEST-23-1955, TEST-23-1956, TEST-23-1957, TEST-23-1958, TEST-23-1959, TEST-23-1960, TEST-23-1961, TEST-23-1962, TEST-23-1963, TEST-23-1964, TEST-23-1965, TEST-23-1966, TEST-23-1967, TEST-23-1968, TEST-23-1969, TEST-23-1970, TEST-23-1971, TEST-23-1972, TEST-23-1973, TEST-23-1974, TEST-23-1975, TEST-23-1976, TEST-23-1977, TEST-23-1978, TEST-23-1979, TEST-23-1980, TEST-23-1981, TEST-23-1982, TEST-23-1983, TEST-23-1984, TEST-23-1985, TEST-23-1986, TEST-23-1987, TEST-23-1988, TEST-23-1989, TEST-23-1990, TEST-23-1991, TEST-23-1992, TEST-23-1993, TEST-23-1994, TEST-23-1995,

In the log it shows, below error, not sure if this is relevant.

Story with name '' and opath [id=0x9400046d, page=-2, inst=0, custom=-1] was not fully formatted.

I suspect, it fails when the content is going to next page. Please if I can have some suggestion how to fix it.

Thank you !

Tobi Schumann

Hi Sachen,

is it possible, that your table location is on inline mode and not on paragraph?

Click on the table and check the end of the properties.

Best

Tobi

Vyv

Hi there, the error suggests that you are trying to print something that there is no room for.

So check that the page, frame, story, table, row and cell can all flow, break, allow content to split and so on.

Try to simulate it with a repeater set to many sample counts to test your settings and check it out in Document View.

Good luck.