Fatal error: Device type no longer supported

Sachen · 2025-06-18T08:02:36+00:00

There was an error rendering this rich post.

Hi,

After upgrading from version 5.6.2 to Exstream, I encountered an error when deploying and starting the Control Center:

Fatal error

: Device type no longer supported.
This is spesific to Zebra Printer driver Does anyone know how to resolve this issue?

Thank you

Find more posts tagged with

If there are Accepted Answers, those will be shown by default. You can switch to 'All Replies' by selecting the tab below.

.\drivers\zpl2Pulse.drs(3): Fatal error: Device type no longer supported: ZEBRA

Looks like you have a custom driver that did not make it through the other side during the upgrade. This normally works just fine.

Why not try to create it again (possibly from scratch) and configure your connector driver settings to match the previous project?

Hi ,

Done upgrade many times , still the same error. Have manully created Custom Device and imported the driver from the Device tool , Still get

zpl2Pulse.drs(3) Fatal error: Device type no longer supported

Inside your Drs file, what does it say in the first few lines?

Here is first few lines in drs file.

=======================

Codepage UTF8
Driver "Zpl2Pulse" Zpl2
ContentType "application/octet-stream"

//* Options ---------------------------------------------------------------------------

Option "Print Mode (^MM)" BeforeProc
Choice "Default" "-999"
Choice "Tear Off" "T"
Choice "Rewind" "R"
Choice "Peel Off" "P"
Choice "Cutter" "C"

Option "Media Type (^MT)" BeforeProc
Choice "Default" "-999"
Choice "Thermal Transfer" "T"
Choice "Direct Thermal" "D"

hmmm… sorry, that didn't help.

The issue is line 3: Driver "Zpl2Pulse" Zpl2

I think it should be

Driver "Zpl2Pulse” Zpl2 Drivermodule

E.g.

I like to keep the ID’s the same all the way through… e.g.

Can you check your set-up?

If I remove the Drivermodule text from my ZPL driver I get your error message:

Thank you Vyv,

That started the service when I added Drivermodule.